As a construction expert with years of experience in the field, I've had the opportunity to work on various types of walls, including stud walls. Plasterboarding a stud wall is a crucial step in creating a smooth and durable interior surface. Here's a detailed guide on how to plasterboard a stud wall:


1. Preparation: Before you begin, ensure that the wall studs are properly installed and that the wall is clean and free of any debris. This will help in achieving a better adhesion of the plasterboard to the studs.


2. Measuring and Cutting: Measure the dimensions of your wall and mark the cutting line on your plasterboard. Use a utility knife to score the plasterboard along the marked line and then snap it to break along the score. Ensure the plasterboard is cut to the correct size to fit snugly between the studs.


3. Cutting Notches: It's often necessary to cut notches into the plasterboard to accommodate electrical boxes or other wall fixtures. Use a jigsaw or a multi-tool for this purpose. Remember to cut carefully to avoid damaging the plasterboard.


4. Applying Stud Adhesive: Apply a generous amount of stud adhesive to the wall studs. This adhesive is specifically designed to bond the plasterboard to the studs, providing a strong and secure connection. Spread the adhesive evenly along the entire length of each stud.


5. Hanging the Plasterboard: With the help of another person, lift the plasterboard into position against the wall studs. Press the plasterboard firmly into the adhesive, ensuring full contact with the studs. Use a rafter square to check that the plasterboard is level and plumb.


6. Securing the Plasterboard: Use plasterboard screws to secure the plasterboard to the studs. Space the screws approximately 150mm apart along the length of the plasterboard and 20mm from the edge. This will provide adequate holding power without tearing the plasterboard.

7.
Cutting and Filling Screw Heads: After all the plasterboards are hung, use a screwdriver to drive the heads of the plasterboard screws slightly below the surface. Then, apply plaster or joint compound to fill the screw heads, creating a smooth finish.

8.
Taping and Finishing: Apply joint tape to the seams between the plasterboards. This will reinforce the seams and prevent cracks from forming. After the tape is in place, apply a thin layer of joint compound over the tape, feathering the edges to blend with the surrounding plasterboard.

9.
Sanding and Painting: Once the joint compound has dried, sand the surface smooth. Ensure that the sanding is done evenly to avoid creating any high or low spots. After sanding, the plasterboard is ready for painting or wallpapering.

10.
Additional Tips: A trick plasterers use to get a better-looking finish is to apply a second coat of joint compound after the first has dried. This helps to further smooth out any imperfections and provides a more professional finish.

By following these steps, you can successfully plasterboard a stud wall and achieve a smooth, durable, and professional-looking finish.

read more >>

Measure the wall and trim the plasterboard to size. Measure the dimensions of your wall and mark the cutting line on your plasterboard. ... A trick plasterers use to get a better looking finish. ... Put stud adhesive on the wall studs. ... Hang the plasterboard on the wall.read more >>