Introduction:

Hi there, I'm an experienced audio engineer with over a decade of experience in designing and installing sound systems. I'm happy to provide you with guidance on selecting the right amplifier for your 2 12-inch subwoofers.

Factors to Consider:

When choosing an amplifier for subwoofers, several key factors need to be considered:

* Subwoofer Power Handling: Determine the RMS power handling capacity of your subwoofers. This is the maximum continuous power the subwoofers can handle without damage.

* Amplifier Power Output: The amplifier's power output should be closely matched to the subwoofer's power handling. Underpowering the subwoofers can lead to distortion and potential damage, while over-powering can also cause damage if the amplifier clips.

* Impedance: Amplifiers and subwoofers have impedance ratings, typically measured in ohms. Ensure the amplifier's impedance matches the combined impedance of the subwoofers.

* Bridgeable Amplifiers: Some amplifiers offer "bridgeable" channels, allowing you to combine two channels into a single channel with double the power output. This can be useful for powering multiple subwoofers or achieving higher power output.

Choosing an Amplifier:

Based on the factors mentioned above, here are some recommended amplifiers for powering 2 12-inch subwoofers:

* Monoblock Amplifiers: These amplifiers are designed specifically for subwoofers and offer high-power output in a single channel. Look for models with an RMS power output of 500-1000 watts at 2 ohms or 250-500 watts at 4 ohms.

* **2-Channel Amplifiers with Bridgeable Channels:** These amplifiers offer two channels that can be bridged to create a single channel with higher power output. Select amplifiers with an RMS power output of 250-500 watts per channel at 4 ohms, which will provide 500-1000 watts at 2 ohms when bridged.

Recommended Amplifiers:

Here are some specific amplifier models that would be suitable for powering 2 12-inch subwoofers:

* Pioneer GM-D9601: 1000-watt monoblock amplifier
* Rockford Fosgate R2-500X1: 500-watt monoblock amplifier
* Alpine MRV-M500: 500-watt 2-channel amplifier with bridgeable channels
* JBL GX-A604: 600-watt 4-channel amplifier with bridgeable channels

**read more >>

Two 350 watts RMS subs together need a total of 700 watts RMS, but an amp putting out from 525 to 1050 watts RMS will do. (75% of 700 is 525; 150% of 700 is 1050.) Using the chart in Step 2, 2 DVC 4-ohm subs can be wired together to form a 1-ohm, a 4-ohm, or a 16-ohm load.read more >>